The short answer
Rollover decides what happens to hours the client did not use. Overage decides what happens when they use more than they bought. Write both into the agreement before the first month, and apply them from the hours log, not from memory.
Our retainers vs projects guide already compares five rollover options with their revenue effects, so this guide does not repeat that table. It covers the parts that decide whether a rule works in practice: which hours are used first, when carried hours expire, what to do the day a retainer goes over, and what to write in the clause.
The three rules agencies choose between
Whatever you call them, an hours retainer ends up with one of three treatments of unused hours:
- Expire. Unused hours lapse at the end of the month. Simple to run and easy to explain, and the strictest on the client. See use-it-or-lose-it retainers.
- Roll for a limited time. Unused hours carry forward and expire after a set number of months. This protects your capacity and still gives the client a cushion.
- Roll with a cap. Unused hours carry forward up to a ceiling, for example 10 hours, and the rest lapse.
We make no claim about which one most agencies use, because we have no source for it. Choose by asking what you can staff. Hours that roll over are work you still owe, so a rule that lets a client bank hours without limit is a rule that can leave you owing a month you cannot deliver.
Which hours get used first
Once hours carry over, a month has two pots: the new month's hours and the older ones. The agreement should say which one work draws down first. We suggest the oldest hours first, because it protects the client from hours expiring unused while newer hours sit untouched, and it is easy to explain.
The choice changes what lapses. A client with 4 hours carried in and 30 new hours who uses 30 in the month has used the 4 old hours first and has 4 new hours left. If the current month's hours go first, the 4 old hours stay in the older pot and are the ones that expire.
How a carried hour expires: a worked example
An example retainer: 30 hours a month, unused hours last for a 2-month rollover period, and the oldest hours are used first. Under this rule, a month's hours last until the end of the second month after it. January's hours run to 31 March. The team logs only 5 hours in each of January, February and March. At the start of April:
| Month | Allocated | Used | Left | Expires |
|---|---|---|---|---|
| January | 30 | 15 | 15 | 31 March (just passed) |
| February | 30 | 0 | 30 | 30 April |
| March | 30 | 0 | 30 | 31 May |
All 15 hours logged so far were drawn from January, because the oldest hours go first. Fifteen of January's hours were still unused on 31 March, so they have reached their expiry date. These three months hold 75 hours between them (April's own 30 hours are added on top), and 15 of the 75 are past their date. Everything now depends on whether your process removes them.
- If expiry removes the hours automatically, 60 hours are left, and the next 20 hours of work draw from February.
- If expiry only flags the hours and nobody removes them, the next 20 hours of work are drawn from January's expired 15 first. The client has effectively been given hours the agreement said had lapsed.
Neither is wrong, as long as the agreement says which one applies and somebody owns the decision. The failure is the third case: a rule that says "expire", a system that does not enforce it, and nobody checking.
When a retainer goes over: overage
Overage is time beyond the hours available. It is not a surprise if you have been watching the burndown, and it is a dispute if you have not. The agreement should answer four questions:
- Approval. Does the team stop at the limit, or may it continue up to a stated number of hours? Written approval from the client before going over protects both sides.
- Rate. What rate applies to the extra hours? We suggest the standard rate rather than the discounted retainer rate, because the discount is for the commitment. That is a choice, not a rule, and you can reasonably choose otherwise.
- Timing. Is overage invoiced the month it happens, or settled against the next month?
- Visibility. How soon is the client told, and how?
A worked example
The retainer from the worked month: 30 hours a month, 4 hours carried into April, so 34 hours available. In April the team logs 38 hours, so the retainer is 4 hours over (38 - 34). Here are three ways to treat the same 4 hours. The rate is a hypothetical figure for the example, not a recommendation.
| Treatment | What happens | Billed in April | May hours available |
|---|---|---|---|
| Bill it | The client approved up to 6 hours of overage in writing on 20 April. The extra 4 hours are invoiced at the example rate. | 4 x 150 = 600 | 30 |
| Borrow from next month | The client and you agree that May is reduced by the 4 hours. No invoice. | 0 | 26 |
| Absorb it | You record the 4 hours as client work you did not charge for, and tell the client. | 0 | 30 |
The third option is sometimes right, for example when the extra time was rework from your own mistake. But it should be a decision with a reason, recorded as non-billable work for that client, so the true cost of the retainer shows up in your utilisation and margin figures. If you quietly absorb overage every month, the retainer is priced too low or the scope has grown. A change request is the tool for the second case.
What to put in the clause
- The rollover rule: expire, roll for a number of months, or roll up to a cap, and the number.
- Which hours are used first.
- Whether expired hours are removed on a date or only when you decide to, and who decides.
- What happens to carried hours if either side pauses or ends the retainer.
- The overage approval step, the rate, and when it is invoiced.
Have your template reviewed by a lawyer in your country. This guide is not legal advice.
Common mistakes
- Letting overage happen first and asking later. A client asked to approve 4 hours on day 20 plans for it. A client handed an invoice does not.
- An expiry rule nobody enforces. It is worse than no rule, because it teaches the client that the rule is soft.
- Using the discounted rate for overage without meaning to. Decide the overage rate before the first month.
- Rolling over without a ceiling. A balance that only grows is an obligation that only grows.